Create an account


Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
XBOX (Original) Error Lights 101 \ Explained

#1
Error Lights 101

Green/Red Flashing -

This is known as the Christmas lights or FRAG frequent red and green error.

Most of the time the screen is blank and if you were doing work recently such as modchipping this could be caused by solder splashes on the mobo or a shot MCPX chip. Removing the MCPX chip is impossible without very expensive equipment so if you can't find any solder splashes or you weren't soldering on the board junk the whole board.

Solid Green However you have no audio video or eject functions -

This is usually has to do with a blown or improperly flashed TSOP bios check the board for solder splashes or wire bridges those people at the xbox linux project found a way to reflash your TSOP and if you see wires or solder from wires removed the TSOP either is linux ready or was destroyed in the attempt you can try and install a modchip if you see no signs of the latter and you should be good as new.

Solid Green However you have no audio video but you can eject -

Well this problem is usually caused by a bad AV cables replace the AV cables and you should be fine.

Orange and Green Flashing -

Well this error is specifically telling you the xbox can't find an AV cable connected to this unit if you do have one then odds are your AV cable is damaged (a frayed or damaged wire). Replace your AV cables and your good to go.

Orange Flashing -

If you've just finished modchiping check the board for solder splashes and remove any you find. This error usually only occurs with novice solderers that don't practice first and pick an expensive board to learn on. Get out your desoldering braid and clear any splashes you find.

Orange/Red Flashing -

You've got a better chance of hitting the lottery then having this code but it happens during mod attempts check pin 5 on your lpc port for a broken trace if you find one fix it by bridging the break with a wire. You will notice small circular traces where a 30 AWG wire can be inserted find the nearest one towards the beginning of the trace and the end and put a wire and (bridge) them.
[Image: 8OHl5AB.png]
Reply



Forum Jump:


Users browsing this thread:
1 Guest(s)

Forum software by © MyBB Theme © iAndrew 2016